Suppliers of HP colour laserjet CM1312 / CP1215 / CP1217 / CP1218 / CP1514n / CP1515n /
CP1518nfi Colour Toner Refills for laser cartridges
It is possible to "override" the chips on these
HP cartridges. The Microchip
counts the number of prints down to zero and then the printer
says the cartridge is "empty" but you can get the
printer to carry on without having to fit a new chip for each refill.
Ask
for the over-ride instructions. A customer told us he did not
have the "Toolbox" installed to allow him to over-ride - Please make sure
that you can Over-ride the chips before refilling. It is a good idea to do
this anyway to ensure that you use up all remaining powder
Complete set of four bottles of
Cyan/Magenta/Yellow/Black Toner Refills for HP CM1312 / CP1215 / CP1217 / CP1218
/ CP1514n / CP1515n / CP1518nfi colour printer
£52.17 + Vat (20%) £59.99
Complete sets of four of Cyan/
Magenta/Yellow/Black HP CM1312 / CM1312N / CM1312nfi / CP1215 / CP1217 / CP1218 / CP1514n / CP1515n / CP1518n Replacement
Chips
£22 + Vat (20%) £25.30
We recommend the Funnels
which are not included with the above.
Laser Hole Making Tool - Necessary for HP
Laserjet CM1312 / CP1215 series cartridges (One only needed)
REFILL TONER INSTRUCTIONS
for HP colour laserjet CM1312 / CM1312N / CM1312nfi / CP1215 / CP1217 / CP1218 / CP1514n / CP1515n / CP1518n Colour Laser Cartridges:
(Please note that refilling is a
practical task requiring some tools & practical skills)
These cartridges are "chipped" but can be set to "over-ride" to allow printing after the refill - much cheaper than
having to use chips! Our
instructions show in detail how this is achieved
REFILLING
1) Make the
filler hole.
2) Empty out
all old toner
3) The pour
can now be undertaken then seal hole.
4) Set the printer to "over-ride"
Required Tools
1. Hole Making Tool
Required Supplies
1. HP CM1312 / CP1215 Toner
Choose the correct colour for the cartridge
2. Clean the exterior of the cartridge. Be careful
not to damage the developer roller as it is exposed.
3. Heat up the Hole Making Tool for
at least 3 minutes then burn the hole in the position shown left. Remove Tool -
the piece of plastic cut out should come away with the tool. Unplug tool and
once it has cooled remove the piece of plastic
Shake out all the remaining toner
into a poly bag (wrap around the hole end) to clean out the cartridge and
dispose of the waste.
Shake your toner bottle vigorously before uncapping fit the filler spout and
then refill cartridge through the hole you made
Cut a strip of Gaffer / Duct Tape - cover the hole and make sure it is sealed
all round. Cartridge is now ready for testing back in the printer
OVER-RIDE INSTRUCTIONS
1. Toolbox - System
set up - cartridge out override - choose on Choose "use override" - apply
- see note at top of page about Toolbox. Make sure you can Over-ride before
refilling. If you cannot do this you would need chips