For T6193 (original and compatible chips)
used in:-
Epson Surecolor SC-T3000 /
T3050
T3070
T3080 / T5000 / T5050 / T5070 / T5080 / T7000 / T7050 / T37070 / T7080
How to use the resetter:
The pins on the resetter should make good contact the terminals on the chip of the tank, be sure to press against the pins firmly.
When the chip makes proper contact with the pins on the resetter, the LED light in the resetter will light up
(starts out RED, and after 2-3 seconds will blink and then turn GREEN). GREEN means a successful reset. If the LED stays red,
it means that the chip on the cartridge is abnormal and not resettable. Once the tank has been reset,
thewaste ink that it has collected has to be removed before installing it
back into the printer.
This
can be done in a number of ways. One is to dispose of the pad and
refill the box with new absorbent material, e.g. incontinence pad can
be cut to size and packed in.
PLEASE
NOTE A SPARE NEW CHIP IS SUPPLIED. If you don't have two tanks to
rotate, it is necessary to fit this chip. Instal the Tank with it
fitted, then remove the tank refit the previously resetted chip again
and instal into printer. You are set to go till the next time!